Dubbele inbouw z-wave schakelaar
MODEL NO. TZ36D, Z-WAVE Dual Wall Switch (3 wire)
The TKB Z-Wave dual wall switch is switching attached loads and is controlled either by the local switching paddle or remotely via the Z-Wave wireless protocol
It is included and controlled in a Z-Wave network by a remote control, a wireless control centre or any other kind of Z-Wave controller including a PC-software.
Beside the local switch the unit can control other Z-Wave units remotely in up to three additional Z-Wave groups, which are associated with this device. Tipping one time or two times the switching paddle performs the control. The left paddle controls the local load while the right paddle remotely controls Z-Wave associated devices only. The association of further Z-Wave devices needs to be done by a Z-Wave controller. The unit is powered by 230V power and needs a pattress box with 230 V power wires for installation. The unit is shipped completely with electronics, switching paddle and mounting frame in white style. It is designed for use within a 3-wire system, which means that a neutral wire is needed for operations.
SPEC.
Power: 230 VAC, 50 Hz
Signal (Frequency): 868.42 MHz
Maximum Load – Resistive: 6 amps (1380 watts) maximum, 230 VAC
Range: Up to 30 meters line of sight between the Wireless Controller and /or the closest Z-Wave Receiver Module
The TKB Z-Wave dual wall switch is switching attached loads and is controlled either by the local switching paddle or remotely via the Z-Wave wireless protocol
It is included and controlled in a Z-Wave network by a remote control, a wireless control centre or any other kind of Z-Wave controller including a PC-software.
Beside the local switch the unit can control other Z-Wave units remotely in up to three additional Z-Wave groups, which are associated with this device. Tipping one time or two times the switching paddle performs the control. The left paddle controls the local load while the right paddle remotely controls Z-Wave associated devices only. The association of further Z-Wave devices needs to be done by a Z-Wave controller. The unit is powered by 230V power and needs a pattress box with 230 V power wires for installation. The unit is shipped completely with electronics, switching paddle and mounting frame in white style. It is designed for use within a 3-wire system, which means that a neutral wire is needed for operations.
SPEC.
Power: 230 VAC, 50 Hz
Signal (Frequency): 868.42 MHz
Maximum Load – Resistive: 6 amps (1380 watts) maximum, 230 VAC
Range: Up to 30 meters line of sight between the Wireless Controller and /or the closest Z-Wave Receiver Module
Lees meer..
Specificaties
- Artikelnummer 64037601
