Z-Wave aan/uit tussen stekker
TZ68 ON/OFF MODULE
This plug-in ON/OFF Module in a transceiver which is a Z-Wave enabled device and is fully compatible with any Z-Wave enabled network. Z-Wave enabled devices displaying the Z-Wave logo can also be used with it regardless of the manufacturer, and ours can also be used in other manufacturer's Z-Wave enabled networks. Remote on/off control of the connected load is possible with other manufacturer's Wireless Controller. Each module is designed to act as a repeater. Repeaters will re-transmit the RF signal to ensure that the signal is received by its intended destination by routing the signal around obstacles and radio dead spots.
Adding to Z-Wave Network
In the front casing, there is an ON/OFF knob which is used to carry out inclusion, exclusion or association. Put a Z-wave Wireless Controller into inclusion/exclusion mode, press the knob on the Module to complete the inclusion/exclusion process.
Installation
1.Plug this ON/OFF Module into a wall outlet near the load to be controlled.
2.Plug the load in to the Module. Make sure the load to be controlled cannot exceed 2990/3500 watts.
3.Turn the knob or switch on the load to the ON position.
4.To manually turn ON the ON/OFF Module, press and release the ON/OFF knob.
The blue indicator LED will turn ON , and the load plugged into the module will also turn ON.
5.To manually turn OFF the Module, simply press and release the ON/OFF knob.
The blue indicator LED will turn OFF and the load plugged into the Module will also turn OFF.
Specification
Operating Voltage
230V/50Hz
Maximum Load
2990 W for UK, 3500W for Germany,France
Range
Minimum 30m line of sight
Frequency Range
868.42MHz
This plug-in ON/OFF Module in a transceiver which is a Z-Wave enabled device and is fully compatible with any Z-Wave enabled network. Z-Wave enabled devices displaying the Z-Wave logo can also be used with it regardless of the manufacturer, and ours can also be used in other manufacturer's Z-Wave enabled networks. Remote on/off control of the connected load is possible with other manufacturer's Wireless Controller. Each module is designed to act as a repeater. Repeaters will re-transmit the RF signal to ensure that the signal is received by its intended destination by routing the signal around obstacles and radio dead spots.
Adding to Z-Wave Network
In the front casing, there is an ON/OFF knob which is used to carry out inclusion, exclusion or association. Put a Z-wave Wireless Controller into inclusion/exclusion mode, press the knob on the Module to complete the inclusion/exclusion process.
Installation
1.Plug this ON/OFF Module into a wall outlet near the load to be controlled.
2.Plug the load in to the Module. Make sure the load to be controlled cannot exceed 2990/3500 watts.
3.Turn the knob or switch on the load to the ON position.
4.To manually turn ON the ON/OFF Module, press and release the ON/OFF knob.
The blue indicator LED will turn ON , and the load plugged into the module will also turn ON.
5.To manually turn OFF the Module, simply press and release the ON/OFF knob.
The blue indicator LED will turn OFF and the load plugged into the Module will also turn OFF.
Specification
Operating Voltage
230V/50Hz
Maximum Load
2990 W for UK, 3500W for Germany,France
Range
Minimum 30m line of sight
Frequency Range
868.42MHz
Lees meer..
Specificaties
- Artikelnummer 64037608
